Webuser30

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 8, 2018 at 12:43 am in reply to: Z Axis Stepper Motor Will No Move the Axis #11141
    Webuser30
    Member

    I figured out my issue. It was the Travel per Revolution ($4tr in my case). It was set to 360000. The others were all 1.2500. Once I changed that, it worked as it should. This value either persisted after I ran the factory default command ($defa=1), meaning the factory default doesn’t change that setting or more worrisome, that that is the default value.

    Either way, I’m back in business.

    October 7, 2018 at 1:12 pm in reply to: Z Axis Stepper Motor Will No Move the Axis #11140
    Webuser30
    Member

    I have a similar issue. Motor4 (my Z axis) will not move. If I switch the cable to another stepper, that new stepper will not move. I have verified that all four steppers work. I have also verified that all four cables/wires work. I’ve narrowed it down to that particular motor/axis on the board. I have tried adjusting the pot (carefully), to no avail.
    What other thoughts do you have? If we decide it’s a bad board, I’m less than an hour away and would appreciate if I could just swap the board out in person vs shipping back and forth.

    Thanks much.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)