SteveP

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Trouble Shooting Setup #11970
    SteveP
    Member

    @cheshirecnc

    You mentioned you figured out your problem with the stepper making noise but not moving. How did you figure that problem out? What was the issue? Im back at this after a break.

    in reply to: TinyG Makes noise but stepper doesn't move #11969
    SteveP
    Member

    Update,

    Its been a whole pandemic but im back at this. I toned out J5 to its solder points on the back of the board and, following its schematic back to the resistor and the various points on motor 4 control chip. Everything seems fine there. Without a microscope everything seems fine visually. Next step I’ll take the board into a makerspace i go to and put it on a scope to compare the pwm waveform. Ill also re visit the config settings as well.

Viewing 2 posts - 1 through 2 (of 2 total)