skinnytod

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: Spindle and speed #5645
    skinnytod
    Member

    Yes, I meant speed, in addition to direction and enable.

    After digging around, I realized I had mashed up some info @ the current version (.8c) and the dev version. Apparently the dev version supports some method of PWM for spindle speed. Currently speed isn’t handled at all.

    Hooking up to pins 12 & 13? I just soldered on some header pins. Those could be connected to a relay or as in my case, a separate Arduino.

    in reply to: Need installation instructions #1626
    skinnytod
    Member

    Thanks – I get the install part now. Last question: were there some user changes that needed to be made to the 1st gen board (cutting a trace or something)? I seem to recall that from the hard copy instructions that came with the board. Maybe I imagined it…

    in reply to: Need installation instructions #1624
    skinnytod
    Member

    Oh wait – Alden, I just saw that you are part of synthetos. Please help me out – there is nothing on the wiki @ installing etc. Here is the wiki link for installing:

    http://www.synthetos.com/wiki/index.php?title=Installing_grbl

    …nothing there. A pdf of the hard copy instructions would be fine – upload to the site or email direct to skinnytod [at] gmail dot com.

    tx!

    in reply to: Need installation instructions #1623
    skinnytod
    Member

    Thanks for the reply. Alas there is nothing on the wiki @ installing the hex file or the tweaks to the board that I recall from the hard copy instructions. The section on the wiki @ installing is blank.I emailed synthetos a few days ago and haven’t heard anything back.

    Sigh…

Viewing 4 posts - 1 through 4 (of 4 total)