i tried increasing and decreasing jerk and feed rate values… the issue on curved paths is when the feedrate is higher irespective of high or low jerk value… between i will need to set high jerk value to finish the job sooner.
Here is the dump..
https://drive.google.com/file/d/1o3PDeULrq2YIKxgNXAq8MF069dIC1MsI/view?usp=sharing
cmcgrath5035 , yes it is a pen plotter. I use mm mode . I use Chilipeppr to sen the G-code and it is generated from illustrator drawing.