elaboratech

Forum Replies Created

Viewing 1 post (of 1 total)
  • Author
    Posts
  • in reply to: Is There Any Decent Option to Chilipeppr? #10354
    elaboratech
    Member

    Thanks for your response. Rats! I’ve seen this topic discussed in other places, but most are older posts and I was kind of hoping that some progress had been made.

    My latest project is a 750,000 line Aspire 3D model and I’ve done tape splitting down to 4 parts which still stresses Firefox to its limit. After about 20 machine hours into the carving, the Z axis decided to start digging for oil.

    This is the 6th attempt at various projects since using TinyG and Chilipeppr and I have only had one successful result. Most projects have been fairly small.

    Anyhow, thanks again for the response. If it wasn’t so early, I would go drown my sorrow.

    ***end of rant***

Viewing 1 post (of 1 total)