cobra_fd

Forum Replies Created

Viewing 1 post (of 1 total)
  • Author
    Posts
  • in reply to: Random thing #11043
    cobra_fd
    Member

    Yes

    “Sounds like it shut down as if a limit switch was hit?”

    It was mid travel so no limits were close. But the reset did not generate the new zero, zero. The coordinates it stopped at were not replaced with zeros after the reset on the tinyg.

    After much poking and prodding, and a few choice idle threats of dismantling and turning it into a rotating baby mobile, I have “solved” the reset issue.

    I did a complete erase of my chrome installation on the computer and reloaded it, along with a few other windows updates, and a fresh page launch of CP seems to have resolved the coordinate readings to zeros across the board. After the re-install, I did cut my project without any issues, thankfully. And yes, we have wondered if we were indeed getting noise induced falses.

    That is our next step, to ensure wiring and routing for the limits, but we were like kids at Christmas when we got it performing, and now we need to fine tune some more.

    Thanks for your reply, and here’s to happy cnc’ing.

Viewing 1 post (of 1 total)