Trouble Shooting Setup page 2

From the original Synthetos forum (2011–2025)

Started by cheshirecnc on in TinyG Support. 17 replies, last activity Apr 27, 2021.

Staff #

As I suspected, there are now many Z axis configurations, many of which are not documented.
Good luck with calibration. In a few months you will appreciate how much you have already learned, be it by trial and error.

#

@cheshirecnc

You mentioned you figured out your problem with the stepper making noise but not moving. How did you figure that problem out? What was the issue? Im back at this after a break.

This topic is from the original forum (April 2021). Your reply starts a new discussion linked to it.

Reply

Different problem? Ask a new question

Back to TinyG Support or latest activity.