Testing Grblshield

From the original Synthetos forum (2011–2025)

Started by dwo0013 on in TinyG Support. 1 reply, last activity Apr 18, 2012.

#

I just hooked my GRBLshield into my Arduino board to test my router. I was able to get the X and Z axis to work properly. The Y axis just made a humming noise. So, I turn the current pot up and it did the same thing still. So, then I swapped the X and Y axis motor connectors to test if it was the board or the motor. All three motors worked fine and the Y axis grblshield pins did motor any of the motors. Is there away to check with a multimeter for resistance or voltage to check to see if something is burnt up or if something else is going on?

Thanks,

Wes

Staff #

It looks like the Y axis is not working for some reason. You did all the tests we would. One question - What does the Y LED do? Barring a simple answer we may need to exchange the board. It's difficult to diagnose without an oscilloscope and some test programs.

This topic is from the original forum (April 2012). Your reply starts a new discussion linked to it.

Reply

Different problem? Ask a new question

Back to TinyG Support or latest activity.