From the original Synthetos forum (2011–2025)
Hi, I have just recently purchased a TinyG and going through the tutorials.
So the problem is that I want to configure tinyG for B and C axis. I am doing
$1ma=4, then G0 B10
but it doesn't work. It says 'ok', but the motors don't move.
same for $1ma=5
Note that $1ma=3, G0 A10 works perfectly fine.
Am I missing something?
What version of firmware are you running?
What does $A and $B and $C tell you?
Have you set the rotary mode? ($aam=3, $bam=3, $cam=3)
Ok it worked!
My B and C axes were disabled ( $bam = 0 )
You’re welcome.
This topic is from the original forum (November 2018). Your reply starts a new discussion linked to it.
Back to TinyG Support or latest activity.