MonkeyManGuy
#12197
I acidentally fried the motor 3 port, I think from the screws not being tight and the wires loosing contact during operation.
Is there a way to repair motor port 3? Theres an electronics technician I know who can repair some boards, if we could have some guidance please?
or
Is there a way to connect a 4 wire stepper motor to one of the ABC rotary axes?
Thank you
Zootalaws
#12198
You can bypass it and use an external driver, which would be the easiest option if you’re not confident desoldering the ob-board one
This is well-documented in the documentation
You can connect external drivers to every port, so do the same for your 4-wire motor on other port
Zootalaws
#12201