Hello all, My Tinyg was working fine. I tried attaching some wiring to the limit switches and things did not go well. I have since disconnected all signsl wires including PWM.
When I connect to Tinyg from coolterm, the PWM light is still on solid. When I press space space enter, I get a continuous stream of {"r":{"r":{},"f":[1,100,34,8877]} and nothing I can do can stop it.
All I want to do is get back to the beginning and start over. I am probably to new to understand what happened.
From you limited description, I'll assume that the PWM light was not on solid before your "event".
The default value of parameter $p1pof is 0.1, so it sounds to me like whatever happened might have reset your parameters.
Entering $p1pof=0.0 should clear the led.
I assume you have tried reset button?
Are you using tinyG or tinyG2?
If tinyG, having an "event" reset parameters is unusual, sort of implies a serious crash. You may need to reload your tinyG firmware. Be aware that reloading firmware will also reset all parameters, so you would need to reload them since that defaults likely do not match your machine.