Output problems... coolant?

From the original Synthetos forum (2011–2025)

Started by ink251 on in TinyG Support. 1 reply, last activity Sep 28, 2012.

#

So I have firmware version .93 according to $ command in tinyg prompt

I attempted to send a M7 while reading the voltage from output 3 (coolant) from this pinout

http://www.synthetos.com/wiki/index.php?title=File:Pinouts-tinyg.jpg

No voltage change...

Am I overlooking something simple? Do I need to define pins somewhere?

Staff #

No, it looks like you are doing things correctly. The lowest LED should turn on when you issue an M7 or M8, and turn off with an M9. The corresponding pin should go low and high (respectively). Does the LED react?

You can try running the on-board diagnostic tests. There is one for the Mcodes. Type $tests and you should get the help screen I believe that Mcodes test is $test=7

This topic is from the original forum (September 2012). Your reply starts a new discussion linked to it.

Reply

Different problem? Ask a new question

Back to TinyG Support or latest activity.