Issue with B and C axis with Due

Started by Kaypi on Apr 28, 2020 in g2Core Projects. 1 reply, last activity May 5, 2020.

Kaypi Apr 28, 2020 #

Hi,

I'm trying to control 5 steppers using g2Core (using Arduino Due), and all axis are working just fine, except for the B-axis or the C-axis. I set up all axis the same, so I don't think there is an issue with the config file that I created. However, when I try to control motor-B, there is no movement on the motor that is connected to the associated pins[37 and 38] (while with X-Y-Z-A I have no issues).
However, when I set 1ma=4, and send a signal for motor-B, the motor does respond at the pins that are associated with the x-axis.
Did anyone else run into this issue?

Thanks!

cmcgrath5035Staff May 5, 2020 #

Sorry, missed this post.
Axis setup for rotary (A,B,C) is different than linear.
Are you sending a valid move code for a rotational motor?

What version of G2Core do you have?
What "Board" file did you compile with?
Using external motor drivers?

Do you really want 2 rotational axis?
G2core can also do X,Y,Z,U,V,W, 6 linear interfaces.

This topic is from the original forum (May 2020). Your reply starts a new discussion linked to it.

Different problem? Ask a new question