grblShield with Arduino and 3 stepper motors

From the original Synthetos forum (2011–2025)

Started by ArneVDL on in grblShield Support. 0 replies, last activity Feb 6, 2015.

#

Hello,

I would like to order a grblShield but first I want to make sure that this is what I really need. The application I will use it for drives 1 motor in X-direction and 2 motor synchronously in the Y-direction. The motor needs to deliver a torque of at least 60mNm at a frequency of 4200PPS.

I searched a bit on the internet and I decided that I want to order a Shinano stepper motor (SST43D2085) with the following specifications:
* 1,8° step angle
* Bipolar
* 3,9V
* 1,13A/phase
* 3,45ohm/phase
* number of pins = 4
* torque of 100mNm @ 4200PPS

Will these motors in combination with the grblShield do the job for my project?

Thanks in advance,
Arne

This topic is from the original forum (February 2015). Your reply starts a new discussion linked to it.

Reply

Different problem? Ask a new question

Back to grblShield Support or latest activity.