g2 wrong axis pin usage

From the original Synthetos forum (2011–2025)

Started by gochisar on in TinyG Feature Requests. 1 reply, last activity May 29, 2017.

#

g2 shield m1_step pin is attached to DUE pin 2.
Arduino DUE pin 2 is low current pin. Max current output is 9 ma.
When step frequency getting high, stepper driver is not saturate enough!

My offer is use SAM3X8E C Port for maximum secure stepping. C Port Pins is power current output.

Staff #

Are you using Gshield on DUE for motor drive or external drivers?

You should consider a 3.3v to 5 V logic buffer for all external driver interfaces.

Or, you could make the pin change you suggest in Motate and recompile.

This topic is from the original forum (May 2017). Your reply starts a new discussion linked to it.

Reply

Different problem? Ask a new question

Back to TinyG Feature Requests or latest activity.