How about a tinyg module that runs your software, but allows me at attach external motor controllers/drivers so I can use bigger motors. Output step/direction/enable that I can use with my own drivers. It would also be a great option for folks concerned that if a driver onboard fails, the board must be replaced.
External motor drivers
From the original Synthetos forum (2011–2025)
There are pin headers on tinyGV8 that make these signals available.
Schematics are here:
https://github.com/synthetos/TinyG/tree/master/hardware/v8schematics
You can interface up to 6 motor drivers if you run tinyG2 on an Arduino DUE.
Be mindful that both tinyG and DUE are 3.3V logic - you may need logic level translators to interface external drivers.
This topic is from the original forum (April 2016). Your reply starts a new discussion linked to it.
Back to TinyG Feature Requests or latest activity.