If I understand right the tinyg is an open hardware project. I was able to see a minimal circuit reference pdf in the github. Are the eagle files and/or gerbers available to actually fabricate the boards? If not why? Thanks.
Eagle files, gerbers, BOM
From the original Synthetos forum (2011–2025)
TinyG source is open source. We also provide the schematics. TinyG hardware is not OSH.
Hello Would it be ok to let me know the value of U7 and P1 components in the V8 Sch much appreciated.
Thanks
On my tinyG U7 is an LM2594 switching voltage regulator
Matches the schematic pinout, it converts Vmot to 3.3V, set by voltage divider R4 and R5.
What is a P1?
You Mean D1? schematic says it is a MBRS140, Shottky Barrier diode
If, as I am guessing, you think you killed this regulator and the diode,
there is a likelihood that the 3.3V bus on the whole tinyG went outside the range 0-3.3V.
That usually means instant death for 3.3V logic, or worse, electrical stress that may result in random near-future death.
Keep that in mind if you set off to repair
This topic is from the original forum (May 2017). Your reply starts a new discussion linked to it.
Back to TinyG Support or latest activity.