Due / gShield w/ g2Core via CNCjs -- No motor output

From the original Synthetos forum (2011–2025)

Started by jjwebster on in Hardware Support. 1 reply, last activity Apr 15, 2020.

#

Hi, I recently built a v1Engineering Lowrider v2... I was able to get up and running with Grbl running on an Arduino Uno w/ gShield v5. I also have an Arduino Due which I flashed with g2Core v101.03 from the prebuilt binary… flash went well, I have the gShield wired in with a 24V power supply. I am using CNCjs running on a Raspberry Pi 3 B+. The g2Core controller can be configured via CNCjs console, and responds via console out to jog commands as if motors are moving, but there is no motion. I found many posts about having to enable the axes via $xam=1, $yam=1, etc… but that didn’t help. I also turn Power Management and Power Levels on/off/sideways/etc. I also tried to jump the “m3enab” pin to ground, and then 3.3v, thinking it may have a physical enable requirement. In addition, I tried running CNCjs on my laptop, and also tried to use Chillipeppr. Nada. I also compiled g2core via my Mac and flashed the .bin (and also tried flashing the .elf to be sure)... and the results are the same.

No matter what I do, I can’t get motion. Do I need connect any enable pins on the Due? As noted, I tried ground and 3.3v on the m3enab pin on the 50-pin header on the Due, but I'm reluctant to randomly probe pins.

Staff #

Sorry, missed thia post a while ago.
Did you get up and running?

M3enab pin is an output, not an input. When using Gshield, which was developed for GRBL FW, all motors are enabled/disabled by the GRBLEnab pin which connects to the shield.

Did you flash or compile using the Gshield header files?

This topic is from the original forum (April 2020). Your reply starts a new discussion linked to it.

Reply

Different problem? Ask a new question

Back to Hardware Support or latest activity.