Droped metal bit on face of board and now it flashes power SpDir and Mot3 lights

From the original Synthetos forum (2011–2025)

Started by Tgrim on Oct 20, 2016 in TinyG Support. 1 reply, last activity Oct 20, 2016.

Tgrim Oct 20, 2016 #

Hi all,

I droped a small metal driver bit onto the surface of a Tiny-G while it was on and the board is either damaged or needs some kind of reset. When it is powered it only flashes the following lights at the same time: power, SpDir and Mot3 and will not respond to commands

hoping to save it, any help or ideas would be great.

Thanks
Tomas

cmcgrath5035Staff Oct 20, 2016 #

I have never seen that light sequence.
I assume you have tried powering tinyG off then on, or hit rest button?
You could try to reflash the firmware, but I fear the damage is physical/hardware, not logical/firmware.

This topic is from the original forum (October 2016). Your reply starts a new discussion linked to it.

Different problem? Ask a new question

Back to TinyG Support or latest activity.