commands are different

From the original Synthetos forum (2011–2025)

Started by Marcel Joe on in grblShield Support. 0 replies, last activity Oct 8, 2016.

#

HI I am new to this forum My name is Marcel.

I just built a cnc plotter that will eventually become a laser engraver cutter. I just put limit switches on it and want them to home in the negative direction. I printed out the list of commands that should be changed. But when I do the $$ to get the list of commands or codes that need to be changed.
Well mine are different then the ones on the setup site. I have a screen shot of the print out. but not sure if I can post it. also I am using 0.9a.
also the wiring of the limits said in 0.9 the z was changed to pin 12 well that was not true it is still 11.

This topic is from the original forum (October 2016). Your reply starts a new discussion linked to it.

Reply

Different problem? Ask a new question

Back to grblShield Support or latest activity.