From the original Synthetos forum (2011–2025)
Hello,
I recently purchased a tinyg board for my ox cnc. The board is able to connected to my PC via USB using chilipeppr, however, I am unable to edit the config for things like motor direction, steps etc.
When I click the settings button, I get this page:
http://i.imgur.com/Dno8pcNl.png
I have also tried to update the firmware using the tinyg updater but also get an error there which says "verify failed!" before it even begins to update the board.
Any help would be greatly appreciated.
Thanks
Be aware that Chilipeppr also has a forum like interface at
Info available either location.
In this case, you will find this issue resolved over last night - an piece of code-in-development was inadvertently turned on.
Refresh your CP browser tab, the older congigtinyG wizard should load for you.
The tinyG updater app is having difficulty on some platforms(OSs).
The older avrdude method still should work:
https://github.com/synthetos/TinyG/wiki/TinyG-Updating-Firmware
Adding the -e option, per
recommended
This topic is from the original forum (April 2015). Your reply starts a new discussion linked to it.
Back to TinyG Support or latest activity.
