Cannot start / communicate with a customboard

Home Forums TinyG TinyG Projects Cannot start / communicate with a customboard

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #9081
    dandumit
    Member

    Dear All,
    I am trying to start a board assembled and programmed by me.
    Board was designed by “PowerBook” user :

    TinyG V8 No Motor Driver

    When I connect /reset the board , after few secconds I get the message : {"r":{"fv":0.970,"fb":440.20,"hp":1,"hv":8,"id":"1G0509-BLN","msg":"SYSTEM READY"},"f":[1,0,0,5376]}`

    But this is almost all. I cannot get other answer from board on any string that I send there. I have been using Bray Terminal and cool terminal.

    Somehow ChiliPeppr seems to recognize this board .
    However It’s not clear for me if is a kind of a bidirectional communication.

    I have tried to upgrade the firmware from Chilipepr. I get a AVRDUDE error:
    “Connecting to programmer: .avrdude.exe: butterfly_recv(): programmer is not responding”

    Could you please advice with what commands I should start to test the board if is answering ?
    I will try next to check again fuse settings. and after that to inspect with an oscilloscope the FTDI serial communication.

    any hints will be greatly appreciated !

    br,
    DAniel

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.