Arduino stops responding after Grbl-Shield is plugged in.

From the original Synthetos forum (2011–2025)

Started by Overloo on in grblShield Support. 1 reply, last activity May 25, 2016.

#

Hey Helpers,

I need help with my Grbl-shield.
If I communicate with my arduino with 0.8c Grbl Software without the Grbl-Shield being connected there are no flaws and no errors accure.(I am communicating throught the Arduino Serial Monitor at 9600Baud)
As soon as i plug in the Grbl-Shield and power it with my already tested 24 Volt Power-Supply the communication shuts down and i get no signal out of it and the returned strings are always "OK" even when i type $$ to view the details.

I hope you can help me soon.
Thanks for helping.

Overloo

#

You are powering down everything before plugging the shield into the Arduino?

This topic is from the original forum (May 2016). Your reply starts a new discussion linked to it.

Reply

Different problem? Ask a new question

Back to grblShield Support or latest activity.