wephotography

Forum Replies Created

Viewing 6 posts - 16 through 21 (of 21 total)
1 2
  • Author
    Posts
  • July 28, 2015 at 11:17 pm in reply to: 440.16 Firmware still having arc issues #8127
    wephotography
    Member

    Also for what its worth prior to the recent changes to chillipeppr that forced me to do fw updates i was running 380.08 build with zero issues.

    July 28, 2015 at 5:29 pm in reply to: 440.16 Firmware still having arc issues #8125
    wephotography
    Member

    See the snapshot for the gcode area triggering the circle cut on the capital letter E. Between lines 503-515 in chillipeppr. I updated to 440.17 as well.

    July 28, 2015 at 5:14 pm in reply to: 440.16 Firmware still having arc issues #8123
    wephotography
    Member

    I added two files. Averygcode, which is the entire cut sequence which did fine until it got to the inner cut of the letter V starting from the base os the V where it was supposed to make the cut up the right it triggered a very large circle. I caught this one and stopped it before it could ruin the entire piece and cut the rest of the V by hand. See the AveryV code set for the error isolated into its own code. I remade just the inner cut of the V and the final round profile to see if that solved my problem but it gave me the exact same result. Also see the ECIRCLEERROR file for that code singled out. That goes along with the jpeg of the circular cut around the capital E with the circle starting on the bottom leg of the E moving counter clockwise.

    https://www.dropbox.com/sh/3xyeh29fyve7nyo/AADwyYdcGdh6QLqcd0xVgsmia?dl=0

    • This reply was modified 9 years, 3 months ago by wephotography.
    July 28, 2015 at 1:07 am in reply to: 440.16 Firmware still having arc issues #8116
    wephotography
    Member

    I run on a Mac so the only method of updating ive ever had any success with is the tinyg updater. Currently only 440.17 is available there. Though it looks the only fixes there was the reset issue. I can add another file that created a circle mid cut as well if you need it and pinpoint the area that it went wrong.

    July 26, 2015 at 8:54 pm in reply to: 440.16 Firmware still having arc issues #8105
    wephotography
    Member

    E circular cut error

    July 26, 2015 at 8:48 pm in reply to: 440.16 Firmware still having arc issues #8104
    wephotography
    Member

    I used makercam for gcode generation and tool paths. Have always used that bc im doing pretty simple 2D cuts. I was running in inch mode with a piece created in inches. Did everything over again in MM and it did the exact same thing as before. Below is a link to the video of whats going on as well as dropbox of the gcode files and snapsots of the code sections where they are going wrong.

    https://www.dropbox.com/sh/3xyeh29fyve7nyo/AADwyYdcGdh6QLqcd0xVgsmia?dl=0

  • Author
    Posts
Viewing 6 posts - 16 through 21 (of 21 total)
1 2