s.carlier

Forum Replies Created

Viewing 1 post (of 1 total)
  • Author
    Posts
  • in reply to: step-down switcher for the 5V supply? #3544
    s.carlier
    Member

    Sounds good! Have you also considered adding a (0.5A?) polyfuse on the 5V supply, and a 2-pin connector to allow powering add-on boards from it? I would love to see these on future revisions.

    I plan to use RS485 to interface with a spindle speed controller (serial communication is more convenient than PWM for my design) and perhaps optical encoders to experiment with closed-loop control.

Viewing 1 post (of 1 total)