Powerbook

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: TinyG V8 No Motor Driver #8845
    Powerbook
    Member

    Hello

    Your board is on the way.

    According to a discussion with Riley from Synthetos, my fork of the TinyG controller need another name to avoid misunderstandings.

    Name for this fork of TinyG board is now : CncBooster.

    I initialize a repository on github (and a wiki page FR/US): https://github.com/Cncfraises/CncBooster

    Need to add many more information, thank you for your patience.

    We keep in touch.

    Regards,

    Chris.

    in reply to: TinyG V8 No Motor Driver #8831
    Powerbook
    Member

    Hello Daniel,

    Don’t “waste” your time to draw a board in Kicad, i could give you the Eagle project 😉
    I will create a git to push files on it.

    About the board.
    All axis are functional.
    I need to perform more tests and finish to configure the board.

    I have a little issue on my first board release, i add level converter on each I/O, but on 4 outputs (spindle Dir, Spindle Pwm, …) i forget to connect the connector to the output of the lever converter, that’s life.

    For my future use it’s a minor issue, but i will update the schematic and apply new route to the PCB.

    If you could solder in good condition by hands TQFP and 1206 components (i think “yes” if your project is a pick and place machine…), i could send to you a “blank” board.
    If you need a complete and functional board, best way is to have a little patience to i finish all tests on actual version, modify the pcb, order a new batch and assemble some of them.

    Nice day.

    Regards,

    Chris.

Viewing 2 posts - 1 through 2 (of 2 total)