PickyBiker

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • in reply to: Software to control TinyG without the internet #11062
    PickyBiker
    Member

    I sure will.

    Thanks.

    in reply to: Software to control TinyG without the internet #11058
    PickyBiker
    Member

    Thanks Zootalaws

    in reply to: Software to control TinyG without the internet #11056
    PickyBiker
    Member

    This is very helpful. I will look into these. Thank you!

    in reply to: TinyG stopped working #10698
    PickyBiker
    Member

    Found the problem

    I tried to set the micro steps to 8 for each of the four channels but I used $ma instead of $mi and mapped all four channels to 8. I just set them back to 1234 for xyza and I have movement again.

    Argh, so much self-inflicted pain.

    in reply to: TinyG stopped working #10697
    PickyBiker
    Member

    “after you continue following the pause, CP sends the complete gCode file, the 3D viewer traces around the design on screen”
    Yes that is correct.

    “Do you see the status messages scrolling in the Serial Port Console widget?”
    Yes, I do see that

    “When the gCode file completes, are you able to again jog the machine, or are the motors still disabled?”
    The toggles do not result in movement on the machine but the toggle commands do show up in the Serial Port Console Widget and the axis widget is showing the appropriate movements.

    Everything appears to be normal except for no physical movement.

    ???

    in reply to: TinyG stopped working #10695
    PickyBiker
    Member

    cmcgrath5035, you are correct about the pause, but that is not the problem. I get past the pause okay and ChiliPeppr thinks it is sending the gcode. I can see the tool moving around on the screen, just not on the router. Also, the simulator/com option is set to com. The only thing that happens on the CNC is the steppers go into hold mode for the duration of the logo run.

Viewing 6 posts - 1 through 6 (of 6 total)