PhaniKiran

Forum Replies Created

Viewing 1 post (of 1 total)
  • Author
    Posts
  • in reply to: Arduino Due + DRV8825 custom shield+ G2 issues #10703
    PhaniKiran
    Member

    Thank you @cmcgrath5035. My apologies for such a late reply. Been busy with school and work.

    I assume you are building from a fork of G2core edge, creating a custom 100.26 or later $fb

    You are absolutely correct. I am on 100.26

    G2core 100.xx runs the new Line mode Protocol, which may or may not be fully supported or debugged when interfaced by Chilipeppr/SPJS. I doubt UGS is ready, I have no idea about Goko.

    Ok that is interesting the new Line mode Protocol. Hmm yes that might be the reason.
    I have gone back and compiled from an older source. But keep getting issues because the source tree looks like its missing some files….

    G2core does support mircrosteps=32, but Chilipeppr does not as yet
    I highly recommend only making parameter changes from the commandline, one at a time, in mm mode. As your parameter settings mature, change the settings.h file and recompile to make your parameters the defaults.

    True.. I have been playing around with various settings and I finally see it going somewhere!

    And, as you for sure realize, you have made a ton of changes that make your environment unique. Add to that G2core being significantly changed and enhanced with fv=100.x. There could be a lot of items to sort out

    Yup I only realized that later. I am trying to wrap my head around all the changes and understand if I have made some other mistakes..

    Anyways Thanks a lot cmcgrath5035 I am going to keep working at it. Shall post back with the completed and working settings and such!

Viewing 1 post (of 1 total)