patamato

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Tinyg crashes at low rpm #9291
    patamato
    Member

    [4ma] m4 map to axis 3 [0=X,1=Y,2=Z…]
    [4sa] m4 step angle 1.800 deg
    [4tr] m4 travel per revolution 1.2700 mm
    [4mi] m4 microsteps 8 [1,2,4,8]
    [4po] m4 polarity 0 [0=normal,1=reverse]
    [4pm] m4 power management 2 (in cycle)

    The only gcode I’ve run so far on the a axis is G1 test moves, since I have the a axis configured in axis mode 1. I am not using A homing.

    in reply to: Tinyg crashes at low rpm #9289
    patamato
    Member

    update:

    using coolterm, I get these error messages whenever this occurs
    {“er”:{“fb”:440.20,”st”:31,”msg”:”Move time is NAN”}}
    {“er”:{“fb”:440.20,”st”:28,”msg”:”Failed to get planner buffer”}}

Viewing 2 posts - 1 through 2 (of 2 total)