oakado

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • April 3, 2015 at 12:57 pm in reply to: Z axis not move in correct way under chilipeppr #7590
    oakado
    Member

    Hi,
    I try some other thing.
    I was miss worked the z limit switch ( min on Max and Max on min) and i try to inverted polarity of z motor and It s working !
    🙂 I done my first cutting test 🙂 its perfect

    Thanks a lot for your help and Sorry, it s my mistake!

    Best regards and Thanks again

    April 2, 2015 at 12:47 pm in reply to: Z axis not move in correct way under chilipeppr #7585
    oakado
    Member

    Hi i’ll go to Check.
    To precise in the serial port command ITs the same as cool term.
    Clicking on + move down and – move up.
    I send other informations just after testing 🙂
    Thanks

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)