Forum Replies Created
-
AuthorPosts
-
nwagsMember
UPDATE: Got new board, #725. Right away this one loads drivers (USB Serial Converter & USB Serial Port) and works with CoolTerm. Not sure what happened to board #2.
nwagsMemberWithout bluetooth… Nothing showing up. USB cable works with Arduino. I used the USB View utility from ftdi. It seems to work despite not officially being compatible with windows 7. Arduino device shows up on it when connected, but nothing shows up for tinyg.
Thank you for your helpnwagsMembermaybe useful
http://www.ftdichip.com/Support/Documents/AppNotes/AN_119_FTDI_Drivers_Installation_Guide_for_Windows7.pdf“5 Troubleshooting
5.1 Windows 7 cannot find drivers for my device
This error can occur if the VID and PID programmed into the device EEPROM do not match those listed in
the INF files for the driver. The VID and PID programmed into the device EEPROM may be found by using
the USBView utility from the FTDI web site. These can then be checked against the VID and PID entries
in the driver INF files. If they do not match, that driver cannot be installed for that device without either
re-programming the device EEPROM or modifying the list of VID and PID numbers in the INF files.
Please note that only your own company VID and PID or FTDI’s VID (0x0403) and FTDI PID issued for
use by the customer should be used in the EEPROM and INF files.”nwagsMemberusing tinyg v8 despite the picture
nwagsMemberWindows 7
https://www.synthetos.com/wp-content/uploads/2012/07/tinygV7.jpg
I’ve connected both ways many times before. Perhaps something happened to the driver?
-
AuthorPosts