nimu7418

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 3, 2017 at 11:54 am in reply to: Help with my Tiny G #10434
    nimu7418
    Member

    Thank you again.

    July 2, 2017 at 11:08 am in reply to: Help with my Tiny G #10432
    nimu7418
    Member

    I appreciate all the help, I will look into this stuff a bit more and get back to you. Just a clarifqction you are saying this board does not do any sort of feedback loop. Do you know exactly what those porta j17, j18 etc are for?

    July 1, 2017 at 1:49 pm in reply to: Help with my Tiny G #10430
    nimu7418
    Member

    Hmm, ok so I can’t use the tiny G with servo motors? I know the four cables out of the stepper are the a a- b b-, which would go directly into the those green ports. Wouldn’t the other holes(ports) in the board be used from a motor driver? But above those ports j17, j18 etc, can those not be used for a servo motor’s encoder directly?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)