nikky

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Home command erratic behavior: ypos changes to bad value #9564
    nikky
    Member

    Hi,

    I am having the same problem with y homing. Whenever i homed y axis ,it sets y value to -ve ymax value(ytm) and its gets double after very homimg .

    I have upgraded its firmware(440.20) today and found this problem immediately. I have changed Y1 is M2 and Y2 is M3”, change to “Y1 is M3 and Y2 is M2” with reversing the $2po and $3po polarity settings.

    I am using coolterm to send gcode file.

    Kindly let me know is there any solution to solve it. Thank you in advance.

    in reply to: GUI for TinyG controller #6953
    nikky
    Member

    Hello,
    I am looking forward to build small Gcode sender(scripting in python) for tinyg.I am a learner.I want to ask is there any chance of getting bootloader corrupt or any damage to it.Please if any one can guide me what care we should take while communicating tinyg serially. Forgive me if i ask something wrong.But i am new one so plz guide me.
    Thanx..

Viewing 2 posts - 1 through 2 (of 2 total)