@cmcgrath5055
Thank you for the reply.
I have tried to upgrade the firmware and use Chilipeppr using 100+ firmware in the past but did not have much success as probing would not function properly or at all. I did find the edge branch that Bantam is using here and Bantam specifica g2 informational page here. Furthermore I am using the Othermill / Bantam UI and I do really like the functionality it (my user interface build is Bantam tools 1.2.2 QT:5.6.0) But it’s just limited in terms of probing functionality.
I will definitely check out Line Mode protocol and check for more info on the issues page.
Going back to my original question tough, to your knowledge is there any way to leverage the probing repot information in a command like G10 L2 p2? or even in something like {“g55″”:{“x”:90,”y”:90,”z”:”0″}}?
Thank you again for your support.
M
