leversole

Forum Replies Created

Viewing 6 posts - 16 through 21 (of 21 total)
1 2
  • Author
    Posts
  • December 10, 2015 at 9:09 pm in reply to: Homing and limits #9106
    leversole
    Member

    I checked and setting G54 zero does not affect teh homed state…anyhow, here is the parameter dump. also, touch plate is doing weird things, like not going to the right height?!? eg,,,plate is 6.57mm thick, after running the z axis could be anything from 3.0 to 7 or 8, and after words, if I return to zero, it is 10+ mm away from the workpeice?!?

    TinyG Dump

    December 7, 2015 at 8:00 pm in reply to: Homing and limits #9091
    leversole
    Member

    Oh yea, it also (as it was completing the job, it hit the switch repeatedly…I know you can set the xmin switch as homing AND imits, but I thought once homed, you could not go past the soft limits…

    November 29, 2015 at 4:43 pm in reply to: Issues #9023
    leversole
    Member

    I solved the riddle of the circles not being round! After much learning about arcs, looking at all of my TinyG settings, and other head/scratching/hair pulling, it dawned on me that my X axis might be two tight, back off some and viola, everything (at least with the circles) is beautiful…I dont think this explains my first post, but after I make some more test cuts, I will go back and recreate the file for my forst issue.

    November 29, 2015 at 12:55 pm in reply to: Issues #9019
    leversole
    Member

    I must have some settings wrong, picture shows what should be a 5 inch circle…I have attached my TinyG settings, can someone take a look please?

    Thanks
    TinyG Settings

    5 inch circle

    November 29, 2015 at 10:48 am in reply to: Issues #9018
    leversole
    Member

    and a picture of the chilipeppr and actual…

    EMF2
    EMF2

    November 29, 2015 at 9:56 am in reply to: Issues #9017
    leversole
    Member

    Here is the GCode for one of the issues…

    EMF_Logo

  • Author
    Posts
Viewing 6 posts - 16 through 21 (of 21 total)
1 2