jland

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: TGfx install? #5155
    jland
    Member

    Hi Riley, the x32 seems to work fine on my Win 7 x64. I did have a problem with arcs which I posted about a couple of weeks ago, but I don’t think it’s tgFX related. My use of tgFX hasn’t been too exhaustive since I’m still waiting for my shapeoko mech kit and have only run programs with the motors on my bench top.

    Cheers,

    Jim

    in reply to: TGfx install? #5153
    jland
    Member

    I had the same problem installing the X64 version of tgFX (Win7). All I got in the start menu was an uninstall shortcut. I then installed the x32 version which worked properly.

    in reply to: Arc endpoint tolerance #5095
    jland
    Member

    The machine is a Shapeoko, although at the moment it exists as 4 motors sitting on a table. 😛

    I ran it through tgfx and coolterm with the same results…

    in reply to: Arc endpoint tolerance #5093
    jland
    Member

    BTW, this is on a TinyG v8 with fw 380.08

Viewing 4 posts - 1 through 4 (of 4 total)