corb555

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Help! Firmware flash problem – motor lights on hard #4542
    corb555
    Member

    I think I know what happened. When I flashed it resets all the config states on the board. Previously I had power management on, after flash it reset m1,m2, and m3 power mgt to off, so the power lights go on. Much relieved!

    in reply to: Help! Firmware flash problem – motor lights on hard #4538
    corb555
    Member

    I flashed 0.96 B 380.05. It seems like the board may be working fine but the motor lights now come on even though the motors are not on. The board responds to status request and I can enable and disable the motors, but the three green motor LEDs always stay on. I’m a bit relieved – I thought I had bricked the board but it seems OK except the for the motor lights.

    I am using CoolTerm on Mac to drive it.

    • This reply was modified 11 years, 2 months ago by corb555.
Viewing 2 posts - 1 through 2 (of 2 total)