cncfurqan

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • April 19, 2019 at 10:15 pm in reply to: 5 Axis setup where are the outputs? #11390
    cncfurqan
    Member

    Thankyou very much for help

    As “cmcgrath5035” said;
    “So you build with the Gshield definitions but you don’t use the Gshield hardware”

    Does it mean?:

    1. Instead of G Shield hardware I should use the external motor controllers
    2. and connect motor controllers to Due-board as per the connection configuration of G-Shield

    April 17, 2019 at 10:11 pm in reply to: 5 Axis setup where are the outputs? #11386
    cncfurqan
    Member

    Hello

    I am aiming for same 5 axis setup but there are only 4 outputs on driver board
    Please clarify, does it mean i will have to use external driver instead of this board, with TinyG as CNC-driver and Due as hardware board?

    My setup will be like:
    – TinyG
    – Arduino DUO
    – 5 External Driver
    – 5 Stepper motors for each axis

    Thankyou in advance!

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)