bjp6555

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • November 28, 2021 at 4:42 pm in reply to: Homing Y #12104
    bjp6555
    Member

    Thank you, I have an ox. I did try reversing the polarity and yes that does work, but it then set the y jog in the reverse direction so I was hoping for a better solution. Having the Y home in the front makes for trouble getting the work in and out of the machine.
    Best regards,
    Brian

    July 9, 2017 at 1:56 pm in reply to: YET anotherHoming Issue #10454
    bjp6555
    Member

    CMCGrath, you hit it on the head! Disconnected the black wire on the 3volt, left the green and red wires in place and X homed very nicely! Going to now setup up Y AND Z, and hopefully all will go well!
    Thank you so much for your support 🙂
    Brian

    • This reply was modified 7 years, 5 months ago by bjp6555.
    July 9, 2017 at 8:56 am in reply to: YET anotherHoming Issue #10450
    bjp6555
    Member

    Limit Switch
    https://drive.google.com/file/d/0B6n02RjzpTAHVTZlRVFOYzF3NkE/view?usp=sharing

    • This reply was modified 7 years, 5 months ago by bjp6555.
    July 9, 2017 at 8:50 am in reply to: YET anotherHoming Issue #10449
    bjp6555
    Member

    When I 1st wire the switch I did a few test runs and it worked!
    The switch I used is from smw3d Limit Switch using the wire that came with the switch!
    Green to ground
    Black to 3.3 volt
    Red to Xmin
    Could I have miss read that Black should go to 3. volt? I would think that Red would would go to 3.3 volt!
    I’ve tried both NO and NC switch type!
    Brian

    July 7, 2017 at 6:59 pm in reply to: YET anotherHoming Issue #10444
    bjp6555
    Member

    So I did a reset on the board, reloaded my parameters and still no luck! Chilipeppr is my choice and I guess I could reset again and try coolterm but my laptop won’t support coolterm! It does seem like the switch is acting like a limit even when choosing Homing! Not sure what to do now!

    July 7, 2017 at 1:18 pm in reply to: YET anotherHoming Issue #10443
    bjp6555
    Member

    Hits switch and stops! disconnects from json server!
    tinyG and Chilipeppr!
    Entered machine settings in inch mode (not sure how to change it back to MM)
    I think I’ll do the reset $def=1 and reenter all settings!
    but 1st I’ll try the 8inch away from home and see what happends!
    Thank you for your suggestions!
    Brian

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)