andypop

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Using the tinyG to control a camera rig! #10924
    andypop
    Member

    Thanks so much for the reply!

    I can confirm line mode is in as I’m using that now to send paths over android + serial USB

    I’ll check out the DUE – in some ways our needs are less intense than 3DP/CNC as our paths and gcode are much simpler and shorter than any 3d print or CNC part cut path. Most of them I can reduce to < than the queue buffer size!

    in reply to: Using the tinyG to control a camera rig! #10910
    andypop
    Member

    Thank you for your response!

    Follow up! Do you feel that we are limiting ourselves by using the tinyG v8 vs an arduino due + g2core or would the motion that either gives you be about the same?
    Strictly speaking about 2 motors and movement in the XY along curves and accel/decel.

Viewing 2 posts - 1 through 2 (of 2 total)