Forum Replies Created
-
AuthorPosts
-
January 29, 2016 at 3:24 pm in reply to: GrblController or UniversalGcodeSender programs with tinyg 8 #9309alhaddarMember
UniversalGcodeSender-v1.0.9
January 29, 2016 at 8:22 am in reply to: GrblController or UniversalGcodeSender programs with tinyg 8 #9307alhaddarMemberI hope that you see the picture
what is the problem
Please help me to get a solution to this problemJanuary 28, 2016 at 2:55 pm in reply to: GrblController or UniversalGcodeSender programs with tinyg 8 #9304alhaddarMemberThank you for helping me
Is it possible to help me more in most settings,
how to enter basic tinyGV8 control and setup by CoolTerm program where I am a novice in this field I owned shapeoko 2Thank you once again
alhaddarMemberDear friend, I tried all the attempts, but unfortunately can not get it off if a way is one which is through the file that you work through the program ArtCAM and put all the information on the speed work with me, but not as fast, which I developed sense healthier, which I can not change the speed also and I researched a lot on the internet and did not get an answer to this problem
Thank you in advance for your help me
Regards
alhaddarMemberThank you for your attention and we wait
alhaddarMemberHello
First, I’m sorry for the delay in response due to travel to and from traveling out of your responses and Wright have returned to my previous post attributed to the painting, which in this link
https://dl.dropboxusercontent.com/u/50261731/tinyGV8spin.pngAnd you experience it, but unfortunately it did not work then I’ve experienced on the Solid State Relay and worked with me directly without problems
alhaddarMemberThank you dear friend to help you
For the link in the first post I tried to link and fairest but unfortunately, there is no adjustment button so that I can modify the linkI said at the level shifter may need in order to operate
Is it possible to help where I am a newbie I hope you put me a picture of an electronic circuit so that I can work even work with me
With my thanks to you
alhaddarMemberhi
Os: windows pro 8 64-bitspecs my spindle controller
http://www.ebay.com/itm/221360480450?_trksid=p2059210.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AITWhat are you using to send Gcode and command to tinyG
m03 for start
M05 for stopWhat do you have connected to what, and how?
alhaddarMemberThank you for your help and I really appreciate you this assistance
He has worked with me excellentlyI hope that arise section of these problems and solutions have been completed for the members so as to ease the burden on you in the future where the members due to this section and looking for a solution to his problem and if they do not get it says to seek help before you
Thank you again and I’m happy to help this
alhaddarMemberalhaddarMemberThank you for your help, but did not explain to me the work of the electronic circuit works until you help me please send me a copy of the electronic circuit so that I can work
Thanks
alhaddarMemberThank you for your response my dear friend
For the link is
http://www.dhresource.com/albu_286016366_00-1.0×0/ssr-25da-25a-solid-state-relay-white.jpgDo you have access to NPN transistor and a couple resistors, and soldering iron?
NoOr, do you require a plug and go solution?
Yes, I hope you helper in that way, or put me in full, and if the best pictures where I am a novice in this area
I mean step by step with my heartfelt thanks in advance to help me -
AuthorPosts