It seems, through fault of my own, or otherwise, I seem to be heating up quite a bit on the surface of the Z axis driver. Turning the trimpot to anything other than it’s lowest setting heats up the driver rather rapidly. Even on the lowest setting, it still feels like it is producing more heat than the other two driver chips when their trim pots are in acceptable running conditons.
I have quite the sinking feeling that I saw smoke come out of somewhere at some point.
The other two axises (axii?) ((those don’t look right))
Shapeoko2 Kit from Inventables
Gshield 5b
GRBL most recent at the time of this post I believe
.
