using tinyg with external stepper drivers.

Home Forums TinyG TinyG Support using tinyg with external stepper drivers.

Viewing 16 post (of 16 total)
  • Author
    Posts
  • #4988
    freemoore
    Member

    Ben,
    I found some thin gauge wire that fitted through the vias on the tinyg board, and soldered them on. Step out was from those, as was direction. I was using the 2-phase drivers myself, no experience with the 5 – good luck!
    Andy

Viewing 16 post (of 16 total)
  • You must be logged in to reply to this topic.