Using Arduino and Gshield as generic stepper controller

Home Forums gShield grblShield Support Using Arduino and Gshield as generic stepper controller

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #9973
    brennanag
    Member

    Hello,

    Is there any documentation on using the gshield (v5) as a generic stepper driver?
    I would not be using g-code, just simple motor operation switching directions.

    Thanks,
    Brennan

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.