ShapeOko and GRBL shield microsteps

Home Forums gShield grblShield Support ShapeOko and GRBL shield microsteps

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #1310
    Jan
    Member

    I noticed there is a modification of microsteps for Z axis. ( from 8 default to 2 microsteps). I also bought from you GRBL shield and I am not sure if I must also make such a modification or not. Can you please let me know?
    Thank you

    #1311
    alden
    Member

    If you are running the Shapeoko I recommend making the Z axis mod. Here is a page describing the rationale and instructions. It’s quite simple and takes about 5 minutes. If you are running another CNC machine like a Zen Toolworks or a Probotix this is not necessary.
    http://www.synthetos.com/wiki/index.php?title=Z_Axis_Mod_for_Shapeoko

    #1312
    Jan
    Member

    Thanks Alden for the reply.
    But why is that modification needed for Shapeoko?

    #1313
    alden
    Member

    The reason is explained on the Shapeoko forum in this post:
    http://www.shapeoko.com/forum/viewtopic.php?f=4&t=221

    #1314
    Jan
    Member

    Alden,Thanks for the reply. You say I need not make the mod if running a different machine from ShapeOko. Is that problem with ShapeOko caused by the fact that ShapeOko uses both belts (X and Y axes ) and rod( for Z axis)?
    I would like to use GRBL shield with a CNC that uses thread rods for all 3 axes.
    Is there any rule how I can find out the mod is necessary?
    Thanks again for the explanation

    #1315
    alden
    Member

    Since you are running 3 threaded axes you do not need the Shapeoko mod. Sorry for the confusion.

Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.