Motor 2 driver malfunction

Home › Forums › TinyG › TinyG Support › Motor 2 driver malfunction

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 1, 2017 at 3:44 pm #10599
    Musab
    Member

    I purchased a tinyg v8 board for an educational CNC project and it worked
    fine at first. before a couple of days, Motor Driver 2 stopped working and the
    indicating led D10 for motor 2 is not flashing when energizing the motors,
    while the others work perfectly fine. I reset the factory settings but nothing
    changed. the board was used just for few number of times. After the driver
    went down the CPU started to heat up very fast and more than usual. now only
    3 motor drivers are working.

    October 1, 2017 at 6:13 pm #10600
    cmcgrath5035
    Moderator

    Hmm, based on the “CPU heats up” comment bad things have happened.
    Don’t hear that much, it could actually be an issue with the CPU rather than the driver.
    Send a summary of this to https://www.synthetos.com/contact-us/ and include info on how/where you purchased your tinyG.

    Mention https://www.synthetos.com/topics/motor-2-driver-malfunction/ , which is this thread

    October 11, 2017 at 6:55 pm #10616
    Musab
    Member

    thanks cmcgrath5035, I sent them twice, and nobody responded.

    October 12, 2017 at 6:56 am #10619
    cmcgrath5035
    Moderator

    I saw your message, they will get back to you.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.