Hardware "Resume from Feedhold"

Home Forums TinyG TinyG Feature Requests Hardware "Resume from Feedhold"

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #6431
    PlasmaG
    Member

    I’d like to use TinyG for my Plasma table.
    The torch could be started with the “Spindle” pin, but then a feedhold in the Gcode is needed until the “Arc OK” signal is present.
    Could a home/limit input be used as a “feedhold resume”? I need only X and Y axis, the Z will be entirely controlled by the AVHC.

    Is it worth waiting for TinyG to have such hardware input, or should I choose GRBL instead with it’s “Cycle Start” input?

    #6432
    alden
    Member

    It sounds like the plasma is similar to starting a spindle and waiting for it to spin up. A common way to do this is to issue dwell command (G4) for some number of seconds. Alternately, you can send the rest of the Gcode file after the arc is OK.

    It would be pretty straightforward to connect the Z min and max pins to feedhold and cycle start functions, but this is not currently a function in the TinyG.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.