grblShield and Mega2560 / DUE

Home › Forums › gShield › grblShield Support › grblShield and Mega2560 / DUE

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 12, 2013 at 7:11 pm #3769
    willem
    Member

    Hey,

    I’d like to build a small CNC system using grblShield, but on the website is stated that the grblShield doesn’t support the Arduino Megas. Is this a pin problem? Is this solvable by not directly plugging the shield on the Mega / DUE?

    Thanks,

    Willem

    February 13, 2013 at 12:01 pm #3774
    alden
    Member

    Technically, it’s grbl that doesn’t support the MEGAs; grblshield would run fine. I think there are some people porting to the mega – so I’d check out the grbl github and issues.

    Alden

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.