G-code Command does nothing

Home Forums TinyG TinyG Support G-code Command does nothing

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #3982
    sfeine
    Member

    A brand new Tiny G, just hooked up steppers, started tuning the current, stepper was vibrating as opposed to moving at all current levels so I turned down the current and cut the power to the board. Now no matter what G-code command or internal test cycle I try, the stepper drivers (all of them, not just the one channel) won’t do anything (not even lighting up the led). The board connects to the computer just fine and settings are set to default.

    I have tried everything that I can think of but to no avail. The stepper drivers simply will not step.

    #3983
    Riley
    Keymaster

    Sfeine,

     

    That sounds very odd.  Lets go ahead and get that replaced.  Send us an email with the subject RMA in it to

    synthetos [at} gmail.com and we can get you going!

     

    Riley

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.