Firmware schedule

Home › Forums › TinyG › TinyG Support › Firmware schedule

Tagged: , , , ,

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 28, 2013 at 11:22 am #5101
    Makerboost
    Member

    Hi,

    I notice there’s a lot of work going on in the dev branch of the TinyG code, and I wondered if you guys have a rough estimate of when you’ll start pushing it into edge? I’m asking because my machine is acting too weird to do any serious work on right now, and I know that Alden has probably fixed my problem in dev (see thread “more jerking than on linuxcnc”).
    I’ve tried dev a month ago, but had to revert to edge right away because the dev code was very slow, stuttery and chaotic.
    I’m considering spending some money for a more mature system with LinuxCNC or Mach3, but that could be wasted if the TinyG would get stable any moment now 😉

    December 29, 2013 at 2:26 am #5104
    alden
    Member

    We expect to push an edge branch by the end of the year. After about a month of soak time it will go to master. Thanks for your patience.

    December 29, 2013 at 5:24 am #5105
    Makerboost
    Member

    That’s great news. Thank you for the update!

    December 29, 2013 at 5:54 am #5106
    alden
    Member

    I realize that this is just 2 or 3 days but this has been in the works for a while.

    December 29, 2013 at 5:57 am #5107
    Makerboost
    Member

    Just a question about updating firmware, as I never really know for sure. Is it best practice to revert to factory settings after flashing? I.e. using $defa=1

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.